The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Bosch 800cc high impedance

thedsmguy

Well-known member
Joined
Mar 20, 2009
Messages
1,785
Location
Vancouver Washington
I see that if you turn the Base fuel pressure up they can flow 1040cc Even at 800cc they will handle my 400whp goals I bet. Any reviews on these specific injectors?

Thanks
 

beaner

Well-known member
Joined
Jun 22, 2005
Messages
1,562
Location
b'ham, mi
You know our cars use low impedance right? AFIAK the resistor pack would have to be cut off and all wires (4?) soldered together to run high impedance. Any injector will flow with higher base, but why when the ecu is expecting 37? I don't see a reason to mess with this when you can buy any size/impedance injector set for $300 or less. I'd just sell them and buy some 1050's.
 

beaner

Well-known member
Joined
Jun 22, 2005
Messages
1,562
Location
b'ham, mi
So yeah, there's the resistor pack harness cut and all 4 wires connected together. Not sure why someone would buy that.
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top