Diego
Well-known member
My master cylinder won't feed any fluid through the line to the slave. If I push on the fork and press the slave in it will get stiffer but the peddle is dead... any solutions?
The Top Mitsubishi Galant VR-4 Resource
Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.
- Software Upgraded - Reset Your Password to Login
In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.
Can't bleed my clutch
- Thread starterDiego
- Start date
toybreaker
iconoclast
- Joined
- Apr 30, 2006
- Messages
- 3,581
I'll be headed up your way today.
Do you have an air compressor at your place?
I can bring my vacuum bleeder, and we can get this job done.
Do you have an air compressor at your place?
I can bring my vacuum bleeder, and we can get this job done.
Diego
Well-known member
See you in a bit, now to get Justin up here for some fun...
Brunoboy
Well-known member
isnt the master cylinder rod the cause if it doesnt move or not? adjust it first so that the bleeder opens or closes?
Diego
Well-known member
Had TB out here to look it over, upon inspection, the cylinder takes in air instead of pushing fluid out...
TB is looking for a master for me from one of his local friend.
TB is looking for a master for me from one of his local friend.
