The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Nile Black GalantVR-4 (756/2000)Corpus Christi, Tx. SOLD!

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
Condition:

No major dents and decient paint for a 17 yr old car. (PAINT IS NOW FADED ON ROOF OF CAR, CLEAR IS PEALING ON REAR SPOILER). Nile Black with 95-98% tread life left. One small 1/2 dollar size rip on the dash by production # but can be glued back and Im sure would be hard to notice. Leather is hard and seams are ripped on top of rear seats, with some wear on drivers seat near adjustments... however there are no rips, stains, or tears (SEEMS HAVE SEPARATED ON THE TOP OF REAR SEATS-SUN EXPOSURE). 14b turbo crapped out 1st yr I owned it. Replaced with a very nice low milage 14b from a friend of mine. Compressor is ported and polished as well as hot side. Factory exhaust manifold had cracks so it was replaced with a EVOIII and was ported and polished to match the turbo as was the o2 housing (also a EVOIII). It also has a Keydiver EPROM ... stock took a crap and Jeff was nice enough to find me a EPROM, socket it, and chip it with every option (also have stock chip). Everything else on the car is stock.

Current engine in the car has no knocks, leaks, idle is steady, and compression is 160-158. Body has 180,000 on it, not sure about the engine and rest of the drivetrain. Tranny shifts smoothly but can be notchie in second if shifting over 5k. A/C and heat are both in excelent condition as are the brakes. All power buttons work. AWD and AWS are intact and work as they should.


Now for the bad:

When I put the EVOIII o2 housing I wasnt aware that it wouldnt mate up to the stock down pipe so I cut it at the end of the bend. The rest of the exhaust is there and bolted up but its missing about 1' from the o2 housing to the end of the bend on the down pipe. LAST YR DEVELOPED A DRIP BETWEEN THE FUEL NECK AND GAS TANK.. FILL OVER 1/2 A TANK AND YOU WILL HAVE A BASEBALL SIZE FUEL STAIN ON YOUR DRIVE WAY IN THE MORNING. Could use a couple of hundered dollars in body work and a nice paint job to finally start turning heads and get the attention it should.



I am not 100% firm on the price and will work with anyone that is interested and can give this car a good home... I would rather it sit here for another 2yrs in my drive way till my wife finishes school so I can finally have the money to fix it, then have someone buy it only to neglect or miss treat it and have it parted or junked.


Just noticed yesterday that the dash is lifting from the vents near the passenger side and there is some discoloration about the size of a 12" ruler where the sun has beat on it... so I'm dropping $300 off the price ... would imagine ball park of what it would cost to find a dash, ship, and get it installed. Should have car covered this car a long time ago.

New :
Timing belt pulley kit, w/accessory belts
Timing belt tensioner
EGR block off plate
Water pump
Fuel neck
Balancer pulley was bad and replaced with good condition pully from on of the members here.

NEW PRICE $2,250 OBO NOW HAVE ORIG. TITLE IN MY NAME AND CAR IS REG. IN TEXAS WITH CURRENT STICKER.

Here's the vin JA3CX56U2MZ011937

Contact info... if anyone is interested you can reach me on my cell day or night.. Cell # 361-737-2748 (Corpus Christi, Tx.) e mail is [email protected]
 
Last edited:

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
OOPS!... forgot the pics.

random10284.jpg

random10285.jpg

random10286.jpg

random10287.jpg

random10288.jpg
 
Last edited:

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
Need to make room... new price, $2,500
 

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
No, but I can easily take some today after work.
 

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
Took some better pictures today and interior and exterior. Car still needs to be cleaned up a bit but it gives you a better idea of what it looks like.

IMG_1985.jpg


IMG_1986.jpg


IMG_2055.jpg


IMG_2054.jpg


IMG_2039.jpg


IMG_2051.jpg


IMG_2050.jpg
 

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
IMG_2049.jpg


IMG_2048.jpg


IMG_2047.jpg


IMG_2046.jpg


IMG_2045.jpg


IMG_2044.jpg


IMG_2043.jpg


IMG_2042.jpg
 

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
IMG_2037.jpg


IMG_2036.jpg


IMG_2035.jpg


IMG_2034.jpg


IMG_2033.jpg


IMG_2032.jpg


IMG_2031.jpg


IMG_2029.jpg


IMG_2028.jpg


IMG_2027.jpg
 

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
IMG_2026.jpg


IMG_2025.jpg


IMG_2024.jpg


IMG_2023.jpg


IMG_2022.jpg


IMG_2021.jpg


IMG_2020.jpg


IMG_2019.jpg


IMG_2018.jpg


IMG_2017.jpg


IMG_2015.jpg


IMG_2014.jpg


IMG_2013.jpg


IMG_2012.jpg
 

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
Leather seats were just conditioned... there are no discolorations or spots on them... however they are hard in some areas and thats why there is so much leather conditioner on them. There is some split seams and I have taken the pics to show those areas.

IMG_2011.jpg


IMG_2010.jpg


IMG_2009.jpg


IMG_2008.jpg


IMG_2007.jpg


IMG_2006.jpg


IMG_2005.jpg


IMG_2004.jpg


IMG_2003.jpg


IMG_2002.jpg


IMG_2001.jpg
 

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
IMG_2000.jpg


IMG_1999.jpg


IMG_1998.jpg


IMG_1997.jpg


IMG_1994.jpg


IMG_1993.jpg


IMG_1992.jpg


IMG_1991.jpg
 

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
IMG_1990.jpg


IMG_1989.jpg


IMG_1988.jpg


IMG_1987.jpg
 

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
Sorry with the up loading of all the new pics I forgot to post the new price... $2,000 O.B.O. can't seem to stress that enough LOL OR BEST OFFER. Who knows you may find me a generous mood and I my let it go for much less... hint, hint.

The white GSX you see in the garage needs a little oil leak fixed, and was thinking about the fp 3176hta, and some 1000cc inj., hks cam sproket, and maybe a set of 2x cams. Now I know I wont be able to all of that but selling this car will get me going in the right direction.
 
Last edited:

yeti

Well-known member
Joined
Oct 13, 2010
Messages
803
Location
san diego california
are you willing to ship the car to san diego california....
friend of mine just crashed his gsx today and is looking for a gvr4
 

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
$1,800.00 obo ... and Im taking a big loss here as it is, title, reg. taxes, late reg fees cost me $260
 

Given the potential for an overheating situation due to the water pump, would you take $900 for it? Cash.
 

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
Yes I still have it, potential buy wants it in road trip condition so Ive actually bought the parts and should be ready to go this weekend. He wants the car fixed, and me to vid it running and have a compression test done... I told him ok but the $1800 was as is, he said ok, but I have yet to see any money and haven't heard from him in over about 2 weeks.

will be replacing the water pump & bolt kit, bse kit, timing belt kit with accessory belt, BLE timing belt tensioner, and STM engraved EGR block off plate.... came with bolts and gasket, and I don't need to put the EGR back on which was a plus, besides I liked the way it looked. LOL

Oh and new battery.

Bought everything is from STM. Timing belt and water pump are OEM

Price going up, since it will not need any repairs and will be able to be drive to its new home. $2,200
 
Last edited:

RACER-X

Well-known member
Joined
Jul 29, 2004
Messages
423
Location
Corpus Christi, Tx.
Quoting stxvr4:
Given the potential for an overheating situation due to the water pump, would you take $900 for it? Cash.



Are you serious, your dumb enough to want to drive it knowing full well you could lose the engine cause you didn't make arrangements to have it towed or shipped, then you shouldn't own one if that's the way your going to care for it... I sure as hell wouldn't sell you mine, I don't care if you offered me $5,000 cash. And $900, that's just laughable, shells go for more then that, thanks... i guess, but hell NO!
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top