The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Unmodify the front knuckle.

Gtpdz

Well-known member
Joined
Mar 12, 2015
Messages
140
Location
Gig Harbor, WA
So I guess I should post a bit as my first contribution to the how-to archive.

If you have modified 1g/VR4 front knuckle's hole to 14mm to accommodate EVO strut, but you want to switch to 12mm hole struts, here is a very easy and simple way to do that without swapping out the knuckles.

Click here


This particular piece it's a small piece of plain sleeve bearing that can slide into the enlarged knuckle hole. If your modified hole is properly sized it will slide in tight and your 12mm bolt will stay there as it should.

img.php
 

iceman69510

Turn Right Racing
Staff member
Joined
Mar 5, 2001
Messages
10,964
Location
Michigan
Good find. Motion Industries is a good place to find things like bearings, lubricants, anti seize compounds, etc.

I had one near work a few years back and used them for stuff occasionally.
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top