The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Alternative way to mount 4 relay mini box

4Grim

Well-known member
Joined
Sep 30, 2004
Messages
2,514
Location
Orlando FL
Ever since I relocated the batter to the trunk, the mini 4 relay box that is suppose to mount on the positive terminal of the battery just hangs and not secure to anything. Decided to at least find a way to have it secure rather than just hanging around. Depending on your setup and considering if you are running a MAF, intercooler piping, etc etc...you might locate your relay box somewhere else.

Here is the mini relay box prior not secured to anything.

IMG_1340.jpg

IMG_1332.jpg


I happened to have a spare HID ballast mounting bracket and thought it would be a great canidate as a bracket for the mini relay box.

IMG_1333.jpg


It didn't fit perfectly..so I had to unbend the "arms" and rebend them to fit the relay box. The only issue now is how to fully secure the relay box to the bracket since it only held on 3 sides. So what I did was drill holes on the end of each arm so I can fit a zip tie through the hole. I had to use 2 regular length zip ties to wrap around the box to the other end of the bracket arms, if you have 1 single extra long zip tie..that will work too and have a "cleaner" look.

IMG_1334.jpg


So basically you just secure the mine relay box to the bracket and the zip tie(s) to fully secure it to the bracket.

IMG_1335.jpg


This is what it looks like fully tightened on the HID ballast bracket.

IMG_1336.jpg

IMG_1337.jpg


Not just snip the excess zip tie and mount the bracket. I used a existing hole on the frame and just had to make the holes on the HID bracket bigger to flip the bolt through it and mount it to the frame. Depending where you mount yours will be different, but this is how I mounted mine with my setup.

IMG_1338.jpg

IMG_1339.jpg
 
Last edited:
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top