The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

FS: Clutchnet, ACT, Fidanza, 3-bolt LSD, 7cm housing, AGM Battery

belize1334

Well-known member
Joined
Nov 18, 2003
Messages
3,316
Location
Bozeman, MT
Prices dropped...


** GSS342 Walbro 255 HP. $40


** NIB Mitsu Throw out bearing. $20


** NIB BS Elim kit. $15


** Crower springs with Ti retainers. Pulled out of a used head, very good condition. $100



** Set of 16 good condition valves. Mostly OEM with 2 aftermarket on intake side. $30


** Set of 16 cam rollers. Sorry, no picture. $30


** Clutchnet 2x Red with sprung 6-puck. A few thousand miles on it. $100
** Fidanza Flywheel. Will need a new surface if used with a different setup. $70
I'll take $150 for the combo. Flywheel and disk pending



** Orbital 850CCA AGM battery. $50
 
Last edited:

VR4Scott

Well-known member
Joined
Feb 9, 2008
Messages
582
Location
Orlando, FL, USA
What are the measurements of that battery?
 

belize1334

Well-known member
Joined
Nov 18, 2003
Messages
3,316
Location
Bozeman, MT
8" tall x 9" wide x 7" deep, not including the little post extensions on top.
Here's a link... click
 
Last edited:

dsmless

Well-known member
Joined
Jun 12, 2008
Messages
224
Location
tucson,az
are the tien camber plates vr4 specific??
 

belize1334

Well-known member
Joined
Nov 18, 2003
Messages
3,316
Location
Bozeman, MT
Pulled the valves and springs out of the head and dropped the price on the clutch. Somebody buy this stuff.
 

belize1334

Well-known member
Joined
Nov 18, 2003
Messages
3,316
Location
Bozeman, MT
Bump for price drop. Help me clean my garage out so that I can move...
 

ktmrider

Well-known member
Joined
Sep 10, 2007
Messages
3,128
Location
Tempe, AZ
Roger get me a shipped price on the 3-bolt and springs/retainers to 87122 NM thx.
 

JoeDaddy0

Well-known member
Joined
Aug 3, 2009
Messages
63
Location
CA, USA, Beverly Hills
do you have splash guards under the car? both front and two under timing chain and passanger side under car? Front wheel fender liners?
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top