**DONOTDELETE**
(Unregistered)
05/01/06 12:18 AM
5 lug swap, parts needed?

what parts will i need to do the swap? the major stuff is obvious but is there a list somewhere detailing just what is needed? i dont want to end up over looking some odd item.

lunchbox
(:ugh: face)
05/01/06 05:44 PM
Re: 5 lug swap, parts needed?

Front spindles and brake rotors
Rear spindles and brake rotors

Must be from an AWD car.
Must be from an AWD/ABS car if you want to keep the ABS working.
Front rotors must be from a big brake car, or buy new ones.


strokin4dr
(fighting them with a large needle)
05/01/06 09:01 PM
Re: 5 lug swap, parts needed?

The front spindles can be from any TEL, not just the awd models. You have to use your stock knuckles and just press in the TEL spindles w/ new bearings. This is of course if you do not care to keep your abs .

**DONOTDELETE**
(Unregistered)
05/01/06 10:25 PM
Re: 5 lug swap, parts needed?

the car already doesnt have abs so it doesnt matter. so i need the front and rear spindles from an awd t/e/l, or the fronts can be from a non awd? the calipers and harware are universal i assume?

sleepyvr4
(I Hate Kitty Cats)
05/02/06 06:31 AM
Re: 5 lug swap, parts needed?

The fronts can be from a fwd. hardware/calipers are universal.

lunchbox
(:ugh: face)
05/02/06 08:25 AM
Re: 5 lug swap, parts needed?

The front SPINDLES can be from any DSM but the hubs you can either re-use GVR4 hubs or use a complete set of AWD DSM front hubs.

AWD DSM and FWD DSM use the same spindles but different hubs in front. Sorry for the lack of clarification.



Contact Us | Privacy statement GalantVR-4.org

Generated in 0.005 seconds in which 0.003 seconds were spent on a total of 4 queries. Turbo powered.


Hertz's Galant VR-4 Page