Brunoboy
(Jesus Clips)
06/18/11 05:18 AM
car doesnt want to stay alive.

So I replaced the flywheel with a Fidanza Lightened flywheel, Put the new trans in, everything is hooked back up but now I start the car, and it idles for a few seconds and bogs/dies out. is it because of the flywheel or what else can it be?
-Shane


Lancer99
($6500 obo)
06/18/11 08:55 AM
Re: car doesnt want to stay alive.

Sounds like maybe vaccum leak ...maybe vaccum lines or hoses?

Barnes
(Firechicken)
06/18/11 01:34 PM
Re: car doesnt want to stay alive.

The flywheel is not to blame. You screwed something else up in the process of removing and reinstalling the transmission. Think about what components you removed during the install. Now go back and inspect those components. Did you plug everything back in? Did you accidentally unplug something else? Did you pinch or cut a vacuum line in the process, etc etc.

Brunoboy
(Jesus Clips)
06/18/11 01:52 PM
Re: car doesnt want to stay alive.


I will go over it today , thanks, I must've disconnected something in the process.


Brunoboy
(Jesus Clips)
06/18/11 02:58 PM
Re: car doesnt want to stay alive.

Maf connector was dirty, and I was running my old tune in Link....Reset the ecu and it ran fine. Thanks


Contact Us | Privacy statement GalantVR-4.org

Generated in 0.003 seconds in which 0.003 seconds were spent on a total of 4 queries. Turbo powered.


Hertz's Galant VR-4 Page