The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

WTB: rear calipers, 3g lifters

tacolibre

Active member
Joined
Dec 21, 2012
Messages
37
Location
Spokane Valley, WA
in need of rear calipers for a 91 GVR4 and 3g lifters or equivalent shipped to 99004
 

G

Staff member
Joined
Feb 24, 2004
Messages
8,896
Location
zompton
You don't have ANY rear calipers in your posession?
 

tacolibre

Active member
Joined
Dec 21, 2012
Messages
37
Location
Spokane Valley, WA
yes i do, i have both rears but 1 is sticking so i figure a rebuild won't cut it since its prolly the piston sticking to the casting
 

G

Staff member
Joined
Feb 24, 2004
Messages
8,896
Location
zompton
Go to autozone or advanced auto parts and buy reman's. They will ask for your old ones as cores.
 

jnava

Staff member
Joined
Apr 18, 2008
Messages
2,073
Location
Arlington, Tx
I have a set of ITM 3g lifters bnib.
 

Wizardawd

Well-known member
Joined
Aug 7, 2007
Messages
1,323
Location
Franklin, NC
Quoting G:
Go to autozone or advanced auto parts and buy reman's. They will ask for your old ones as cores.



Hard to argue there. Lifetime warranty, new brackets, and washers for $50-60. Honestly most rear calipers on these cars are bad due to age or improper installation of rear pads causing the rears to stick.

Wiz
 

tacolibre

Active member
Joined
Dec 21, 2012
Messages
37
Location
Spokane Valley, WA
I have already recieved supposed good calipers for 45 shipped for the pair. pm sent to jnava regarding lifters

wiz,

how can i tell if the pads were installed properly?

also, regardless of how they were installed how can i confirm that I am installing them properly? rtfm? /ubbthreads/images/graemlins/dunno.gif
 

G

Staff member
Joined
Feb 24, 2004
Messages
8,896
Location
zompton
/ubbthreads/images/graemlins/bawling.gif /ubbthreads/images/graemlins/bawling.gif /ubbthreads/images/graemlins/bawling.gif /ubbthreads/images/graemlins/bawling.gif
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top