strokin4dr
Well-known member
Needs to be in good shape. LMK what you have. Thanks
The Top Mitsubishi Galant VR-4 Resource
Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.
- Software Upgraded - Reset Your Password to Login
In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.
WTB: Passenger fender and trunk lid
- Thread starterstrokin4dr
- Start date
Breakerrr
Well-known member
I have a 90 ggsx trunk lid in good shape. The lights are different and the spoiler is made out of dense rubber or plastic foam...but it'd work
EfiniX
Well-known member
VR4 trunk lid and fender available off my part-out
click
The parts aren't listed per se, but it's a full partout. One note on the trunk: My release cable failed and rather than replace it, I installed a solenoid-based actuator. This didn't require any mods, so you could keep the solenoid and wire in a switch, or you could just put a cable back in.
Rear fender is fine
click
The parts aren't listed per se, but it's a full partout. One note on the trunk: My release cable failed and rather than replace it, I installed a solenoid-based actuator. This didn't require any mods, so you could keep the solenoid and wire in a switch, or you could just put a cable back in.
Rear fender is fine
strokin4dr
Well-known member
Price?
