The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

WTB: GVR4 3 bolt axles.

iceman69510

Turn Right Racing
Staff member
Joined
Mar 5, 2001
Messages
10,964
Location
Michigan
I may still have a set. I will try and check. I am on lifting restriction due to surgery, so I have to see what's in the way. ;)

When you mention cups, are you referring to the cups that attach to the our hub axle shaft? I think I have a spare set of those too.
 

iceman69510

Turn Right Racing
Staff member
Joined
Mar 5, 2001
Messages
10,964
Location
Michigan
Man, I am so sorry I totally spaced on this. I will try and check this week if I still have these around.
 

ggsxkid

Well-known member
Joined
Dec 15, 2005
Messages
918
Location
La vergne TN/Lake Zurich IL
Man, I am so sorry I totally spaced on this. I will try and check this week if I still have these around.
All good man, we all get busy for sure. honestly my idea that I might have one going out a while back seems to be a reality now. Otherwise the post would have probably stayed dormant 😂
 

iceman69510

Turn Right Racing
Staff member
Joined
Mar 5, 2001
Messages
10,964
Location
Michigan
I thought I had replied, but it must have been my earlier post. I don't currently have any stock 3 bolt rears. I will be converting my car to VLSD and the axles in it will be surplus at that point, but I don't know when that will be. :unsure:
 

ggsxkid

Well-known member
Joined
Dec 15, 2005
Messages
918
Location
La vergne TN/Lake Zurich IL
I thought I had replied, but it must have been my earlier post. I don't currently have any stock 3 bolt rears. I will be converting my car to VLSD and the axles in it will be surplus at that point, but I don't know when that will be. :unsure:
No worries. I'll be doing the same as well. Just was trying to stave it off for a bit. Looks like I'll just have to put it on jackstands sooner! :rofl:
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top