The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

WTB: 2.5" DSM BOV flange pipe

jcrimboli

Well-known member
Joined
Jul 25, 2013
Messages
75
Location
Reno, NV
I'm in the process of a FMIC install and I'm looking to pick up the 2.5" tubing with the 1g BOV already welded. Aluminum would be preferred. I know I could buy the 45* pipe with the flange pre-fabbed/welded, but I'm trying to avoid the $70-90 it costs and my flux core welder won't suffice for the job. Let me know.
 
Last edited:

snohacking

Well-known member
Joined
Mar 16, 2010
Messages
233
Location
Menomonee Falls, Wi
I got a 45 degree bend with a flange on it. It came off a ets intercooler piping.
20140503_154057_zpse587d3c0.jpg

$22 shipped.
 

snohacking

Well-known member
Joined
Mar 16, 2010
Messages
233
Location
Menomonee Falls, Wi
P.s.
It is mild steel. I can sandblasted it again to clean the surface rust if needed.
 

jcrimboli

Well-known member
Joined
Jul 25, 2013
Messages
75
Location
Reno, NV
I have the stock one, but I'm building the kit with the 2.5" piping. Hence, the need for the 2.5" pipe.

PM'd you snohacking.
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top