The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Those with ETS intercooler kit

faqinshiet

Well-known member
Joined
Dec 6, 2011
Messages
512
Location
Charlottesville, Va
Hey everyone,
I was going to install my ETS kit this week and was wondering what are you using for the front throttle body elbow bolts? Do I need to find two of the rear bolts and use those? Thanks.
 

strokin4dr

Well-known member
Joined
Aug 30, 2005
Messages
2,770
Location
Savannah, GA
Yep, I used the same bolts as the rear.
 

faqinshiet

Well-known member
Joined
Dec 6, 2011
Messages
512
Location
Charlottesville, Va
Another question regarding the kit is did you have to cut any of the metal at the passenger side at the intake side of the intercooler. The piping is not connect with the intercooler. Thanks
 

ghostinthevr4

Well-known member
Joined
Jun 11, 2008
Messages
587
Location
Fresno, Califonia
The only thing I remember cutting was the front bumper support on the passenger side I did not have to cut anything.

Try putting everything on and installing the couplers loose if you put one on to tight you won't be able to put the other pipes in position.

The kit says you can retain your fog lights but I found it hard to do so I removed mine, that could be giving you a difficult time too.
 

tektic

Well-known member
Joined
Dec 19, 2012
Messages
1,497
Location
ronkonkoma, ny
I trimmed the sheetmetal in front of the passenger wheel. I figured I was better off doing it when I was installing everything than finding out later the ic pipe was making noise and trying to cut it and paint it with the bumper on at a later date.
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top