The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Question about evo mr suspensions

Sam

Member
Joined
Jan 8, 2019
Messages
15
Location
Riverside, CA
I have the MR bilstein with swift springs and about to cut the stock bushing to weld to it.
But before all that, does anyone know how low it will sit compared to the front if its welded all the way up?

Thanks
 

pot

Staff member
Joined
Oct 28, 2003
Messages
1,573
Location
Fayetteville, NC
Hi Sam! Welcome to the galant board. I have attached a link below to give you a general idea of what the process will look like to convert your existing suspension to an Evo XVIII - XIV MR suspension. Please see here:




There is plenty of useful information on this board dealing with this subject
 

tektic

Well-known member
Joined
Dec 19, 2012
Messages
1,497
Location
ronkonkoma, ny
Are you asking for a measurement? Many hear have done the swap including myself.
 

Sam

Member
Joined
Jan 8, 2019
Messages
15
Location
Riverside, CA
I just wanted to know if the rear would sit lower than the front. I went ahead and did it already and the rear sits a bit lower. But not enough to notice if youre not paying attention to it.
 

tektic

Well-known member
Joined
Dec 19, 2012
Messages
1,497
Location
ronkonkoma, ny
What springs are you using? If people swap with stock springs they cut a coil off the front usually. Did you try searching? There’s like a dozen threads on this.
 
Last edited:

BLUELIGHTSBABY

Well-known member
Joined
Sep 17, 2012
Messages
82
Location
Franklin, NC
"EVO 9 MR SUSPENSION ON GVR4 10/21/12" I did a write up on mine with pictures. You will have to search the forum under the technical information forum.
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top