Hondakiller
Well-known member
I just got a prosport wideband gauge. But not sure how to wire up the read wire for the gauge.
Wiring instruction:
Red-12v Accessory power
Black- Ground
Yellow- 12v power
Now this one
Grey- Output signal off the O2 sensor.
So do I splice into one of the wires off the O2 sensor? Or.
Wideband user's:
If you intend on having this gauge work like a wideband will need to install the grey wire on a LC-1(or somthing similar) out put signal. You will also need to change the setting on the back of the gauge to 0~5 volts.
Now what is a LC-1?
I have a scanmaster 3 can I wire the gauge to that?
Thanks
Matt
Wiring instruction:
Red-12v Accessory power
Black- Ground
Yellow- 12v power
Now this one
Grey- Output signal off the O2 sensor.
So do I splice into one of the wires off the O2 sensor? Or.
Wideband user's:
If you intend on having this gauge work like a wideband will need to install the grey wire on a LC-1(or somthing similar) out put signal. You will also need to change the setting on the back of the gauge to 0~5 volts.
Now what is a LC-1?
I have a scanmaster 3 can I wire the gauge to that?
Thanks
Matt