The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Need oil cooler lines help.

Terry Posten

Well-known member
Joined
Dec 16, 2003
Messages
9,009
Location
Davenport, Iowa USA
I need to replace the cooler lines on my stock 90 filter/cooler setup.

I need 4 of the adapters that screw into the housing and cooler.

Where can I get them and what exact size do I look for?

I will get braided line and the nessisary 90 deg and straight fittings needed to connect the two together.

Thanks.
 

CarRacer

Well-known member
Joined
Jun 28, 2007
Messages
4,371
Location
Shakopee, MN
I have my receipt in my car from Summit for my oil cooler setup. I can post you the part numbers if you like.

It's a -10 setup though, but I think that might be advantageous for you as it increases the oil capacity. I'm sure your motor puts out a decent amount of heat. :p

Even if you don't run -10, I'd run 90* and a 120* fitting off of the housing side instead of two 90*. The clearance is very tight to the frame with two 90* fittings.
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top