The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

FS: Part out 92 TSi AWD and misc parts

Wizardawd

Well-known member
Joined
Aug 7, 2007
Messages
1,323
Location
Franklin, NC
I am parting out my old DD 92 TSi AWD 5-spd. Keeping the majority of the driveline such as engine, rear end and front 5 lug hubs. Everything else is available.
Also looking to make room in the garage to start cracking on my GVR4 project.

15" 4-lug Enkeis with Icemaster Ice/Snow tires at around 75% $150
1gb Talon front bumper $50
1gb Talon rear bumper $50
1gb Talon tails, $50 all 3 pieces
1gb DSM headlights $40 pair
1gb DSM turn signals $25 pair
1g radiator fan $25
2g Greddy upper IC pipe $80
GVR4 headlights $50 pair
1 2g SMIC $20
3 1g SMIC $20 each
1g ECU 5-spd Federal Non-Eprom recapped by steve $150
SAFC II Black $200
1gb Talon 16" rims 6 in total, 1 bent $50 each
1g DSM driveshaft $100
6 bolt block with mains and crank $150
1g DSM AWD 5-spd transmission unknown condition $150
Lots of misc parts such as body clips, power transistors, coil packs, throttle bodies, etc.
Also have a couple CD players, 1 Eclipse, 1 Pioneer. $25 each
Kicker 10" CVR sub 4-ohm in a Kenwood powered sub box, wired to be hooked to ext amp $50
JL Audio W0 4 ohm 12" $30
Rockford Fosgate Punch 12" 4 ohm $30
Eclipse 12" sub $30

Pictures will be added when I get off work.

I do need a few parts if you want to trade:
344 mount bracket
Oil pressure sender for electrical Autometer gauge
End clutch assembly for AT transmission

Wiz
 
Last edited:

Epifool

Well-known member
Joined
Feb 6, 2013
Messages
135
Location
greencastle, In
What parts are you lookin for? I need an abs controller from a 92+ tel.
 

Wizardawd

Well-known member
Joined
Aug 7, 2007
Messages
1,323
Location
Franklin, NC
Sorry, car was a non-abs model. And yes, the prop valve is already sold.

Wiz
 

Wizardawd

Well-known member
Joined
Aug 7, 2007
Messages
1,323
Location
Franklin, NC
Keeping the entire rear end assembly for my galant. Sorry.

Wiz
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top