Engine bay fab work finished.

[NZ VR4 RS]

finally got the engine bay work finished off.

had a cold air box,intake pipe,larger breather box and new i/c piping done.

got the wastegate put back into the exhaust so its legal again.





plus a race seat and harness.






While i was in the garage i shot off a few of the car as well.

 

WOW! /ubbthreads/images/graemlins/cool.gif Great Job on the metal work. Looks good!

 

[G]

Looks awesome, what do you think about sand blasting that ex manifold and coating it? I think it would help not melt your hood /ubbthreads/images/graemlins/smile.gif

 

[GSX_TC]

Well done, that is some dam good fab work!

 

I am loving your EVO too! I want out of the states....

 

[bazeng]

Looks good!

What harness is that? I need one to go to the rear seat belt attachment points also..

 

[kama1]

Fab work is great!is that an overflow tank beside the waterneck and intake box?
Harness seems to be from willans.te37s suite the galant very well.

 

[NZ VR4 RS]

here is the link to the harness, the good thing is it is very easy to remove it just clips out from the eyelets you replace your seat mounts with

you use the same eyelets in the bac seat seatbelt mounts as well.

yes is is a overflow for the raditor, it is fed from the bottom of the tank

willians harness

 

[MX4]

Whats that plate say? VR4 ricer?

 

[NZ VR4 RS]

^ you will be covered in the rice from my exhaust.

 

[Terrance362]

Looking good

 

[bazeng]

Do they do a 5 point version in that harness?

When's the tune?

Going for e85 this time?

 

[Specter]

Where are you getting air from for the intake? Did you cut the sheet metal below your intake box?

 

[91bgvr4]

very nice and clean setup !!!