The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Search results for query: *

  • Users: thedsmguy
  • Content: Threads
  • Order by date
  1. FS: H&R gvr4 springs

    I have two sets of springs available. In good working condition. $140 per set plus actual shipping/fees.Thanks!!
  2. FS: Vr4 sunroofs

    I have a couple roofs I can sell. $50 plus shipping. Very heavy, expect shipping to be in the $100 range. Vancouver Washington. Will part out.
  3. FS: Vr4 gas tanks

    I have two tanks, no sending units. Both could use a repaint externally but no rust inside or missing studs for sending units. $150 Vancouver Washington shipping available but expect it to be a 80-100 due to size.
  4. FS: PNW only passenger front seat. Free

    I have a couple extra pass side front seats, not interested in spending my time to shop. Free before they hit scrap. Vancouver Washington
  5. FS: Vr4 dash parts

    No plaque. Vents, wiring, bezel all available. Vancouver Washington, shipping available. Dash has holes drilled in and it's surface is peeling up.
  6. FS: JDM front fenders, JDM trunk, Center vents.

    I have 3 fenders "JDM" with the cutouts for the lights, white in color. I WILL ship these if you're willing to pay for it. $100 each plus shipping. JDM trunk, basically same as USDM $50 Dash vents and dash wiring harness $50. Facebook messages work the best to reach me.facebook.com/thedsmguys
  7. New paint.

    My car is a factory BG car. So, I'm thinking of keeping it green, however I plan on painting the engine bay and door/trunk jams and could do a color swap. I'm curious if anyone has ideas on what other shades look like on a vr4? I'm thinking the chevy corvette lime rock green, or the 2016 mustang...
  8. FS: 4 bolt LSD, 5 lug parts, VR4 Dash, VR4 gas tanks, sending units, filler neck

    $250 plus shipping (Usually $75)These are the rears but I have the fronts as well. $100 for a set of these, and the front hubs (just the bare minimum parts, you'll need to press them into your knuckles)Dash without plaque $100, Dash Plaque $150. Buy both $200 plus shipping!!VR4...
  9. FS: Vancouver Washington 91 vr4 $1000

    Wrecked, clean title, no bad rust, DOES NOT RUN. Oil pump pulley broke off in the wreck. Head is off and has been off a while. Dirty pics are when I first got it, I've cleaned it up some as seen in some pics. I'd sell it AS IS right now for $1000. No offers, No BS. Vancouver Washington. I can...
  10. FS: 1g dsm working eprom ECU.

    Tested in a car recently. $125
  11. FS: Interior pieces

    Hard to list each price, please just PM a fair offer?
  12. WTB: 1991 DODGE COLT ECU needed asap.

    As title says.
  13. FS: Parting out 89 galant

    Seatbelts GONE! Most other things are there. Vancouver Washington.
  14. FS: ABS delete kit $88 shipped

    All 4 needed lines, and the prop valve. Will work in your vr4. From a 92 talon tsi awd. $88 shipped in the USA.Thanks!
  15. FS: complete 92 awd auto dsm partout.

    Vancouver wash. 98 on parts.
  16. FS: Non cruise cable $30 shipped

    Used, but working fine. Thanks.
  17. FS: 5 lug swap ABS version $100 shipped

    For sale is the front hubs (separated at the bearings) and rear stubs from a 93 talon tsi with ABS.$100 shipped. thedsmguys at g mail.com is my paypal
  18. WTB: Pintle caps for stock injectors

    Anyone have some? Or know where to buy them? I don't know exactly which ones to buy. Thanks.
  19. FS: Cyclone intake manifold

    Nicely ported and painted/sand blasted. $150
  20. FS: Factory Vr4 gas tank

    Vancouver Washington. $100
  21. FS: 1990 oil filter housing

    $55 shipped for the housing. Need lines and cooler? I have those too but it adds a decent amount of size to the package so its more costly to ship.
  22. FS: o2 housings Evo3, 2g and 1g/vr4

    Evo3, $75 2g $40 1g/vr4 $20Thanks!
  23. FS: Rebuilt evo3 16g "47" in nearly perfect shape!

    This thing is clean and spins nicely. I just don't have the correct hotside for it. I can send it with a good 14b sized hotside for $350.Pics are available via text for now. PM me with your number.Thanks!
  24. FS: Center and side vents from a vr4 dash

    I have a set of the vents from a dash I just parted out. One broken tab that doesn't affect how it sits in the dash. $30 shipped for the set.
  25. FS: KYB agx and Ground control coilovers

    Looking to get $350 plus shipping on these. Shipping is NOT cheap last set was $99 to ship to east coast! Located in Vancouver Washington.
  26. FS: FP manifold

    Small crack developing in the collectors, did not notice any exhaust leaks but its there. $150 shipped.
  27. FS: BC 272 set

    Looking to sell my nice 272's. No issues. I'm just going to go bigger. $300 they are in good shape, 10k or less miles. Dyno'd over 400 at one point.Thanks. Vancouver Washington.
  28. FS: 5 lug swap setup

    Front and rear. I can send knuckles or just the front hubs, either way I'd suggest doing front bearings. The rear axle stubs are a direct swap and very easy to do.$125 shipped for hubs/stubs. I can also sell brakes and rotors if needed.Thanks.
  29. 2.3 stroker questions on cam selection, valve springs and intake manifold

    Ok, on a 2.0 block with a 100mm crank (makes is a 2.3 right?) motor, what is the best combo as far as cam size, valve spring needs (since they don't rev that high anyways) and thoughts on SMIM effectiveness since it doesn't rev as high as a 2.0.Currently set up with BC 272, AEM cam gears...
  30. WTB: 1g 7 bolt flexplate and spacers

    Thanks, PM me please
  31. FS: Recently parted a 93 awd auto talon, and a 91 gvr4

    Lots of various parts around. Actually I have thousands of parts. I have right now a auto trans, tcase, rearend, tcu, ecu, harness, etc. Plus bits and pieces from a gvr4 that I kept most of the good stuff off of for myself but feel free to ask for anything I have various things just laying...
  32. FS: H&R springs and KYB gr2

    Selling my springs and struts off a recently parted car. $250 seems fair, let me know if it is not.
  33. FS: another vr4 partout

    Wrecked.Bumpers bad, body rough. 4 bolt. No tails.Dash badge $150Pm me with requests.
  34. FS: English racing built transmission

    I'd sell this transmission for $1400 locally.double cone 1/2 taller 5th gear. That is all that I know about the extent of the build, less than 10k since done. Recently inspected by my personal transmission guy.Thanks.
  35. FS: aem wideband

    #1 hardwired (plug drug on ground) $85 #2 no sensor just gauge and wiring (good plug) $60Plus shipping etc.
  36. FS: brake upgrades for 5 lug

    Baer setup, uses 13.1" rotors $400 Outlander big brakes 20mm larger than stock rotor (powerslt brand) $300Plus shipping on either setup.
  37. FS: complete a/c system Price drop to $150

    Everything except the inside the cab parts. $250 local, shipping is your dime.
  38. FS: oem roof rack

    OEM roof rack $300 Bike attachment $50Pm me a cell number or email and I'll snap pics.
  39. FS: Cam Angle Sensors and Coil packs (Fundraiser inside)

    LIV4PSI needs help,I'm going to offer some of my stash.I'd like to see $50 shipped for green top CAS 50% (about $20 after shipping) will be donated to LIV4PSICoil packs 91-94 style or 2g $50 shipped. Same deal, 50% donation of proceeds.Thanks! Please tell me you are from the .org if buying!
  40. FS: Box of hardware (fundraiser inside)

    Looks like LIV4PSI needs some help. All proceeds go to his fundraiser. $25 gets you a small flat rate box full of various condition and sizes of bolts (maybe a few nuts as well) mostly 10mm 12mm 14mm from DSM/GVR4 cars. I think these are about $6 to ship a piece so the rest will be donated. I...
  41. WTB: FP manifold

    Anyone selling one, or perhaps anyone want to trade for something?
  42. WTB: New OEM clutch master cyl

    Anything out there?
  43. WTB: Auto transfer case

    Anything available?
  44. FS: 4 bolt and 5 lug swap for sale

    4 bolt $250 5 lug $100Plus shipping etc.Vancouver Washington Gresham OregonAlso parting out the 93 talon they came out of.
  45. WTB: auto transfer case

    Auto 1g specific transfer case needed.
  46. FS: vr4 gas tank

    Mild rust, still solid and usable. $50 plus however you want to ship. Suggestions on how to ship?
  47. FS: Brand new OEM crank 6 bolt 4g63

    Literally brand new from Mitsu. $450
  48. FS: Aeromotive FPR

    $150. Has lines and adapter for 2g fuel rail (can be used on 1g if you're creative)Has gauge.
  49. FS: Link to my flikr account with over 100 pics of items I have for sale

    Mostly 1g dsm, some gvr4 specific stuff, and some 2g. Also a few misc odds and ends that I post locally to craigslist. PM's are the way to go on this one please! I tried to write out a description for each item including a price. I have WAY more things than this fwiw, these are just the things...
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned
Top