The Top Mitsubishi Galant VR-4 Resource
Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.
- Software Upgraded - Reset Your Password to Login
In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.
TD05 late spool
I recently installed a TD05 16g on my 1990 jdm vr4 and I am now experiencing abnormally bad turbo lag. On this current setup I will not see any positive pressure below 3k rpm. In 2nd gear at WOT past 3k rpm i will see about 0.1 to 0.2 bar between 3k rpm and 4k rpm. going up the rev range I will...Anyone ran a TD05 16g6 10.5T on a VR4
I'm currently interested in a second hand TD05 16g6 10.5T, it's listed for $400 AUD.Has anyone ran these newer TD05s? From my understand I need a evo 4-9 manifold as well and the turbo is the other way compared to the early evos and vr4s. Anyone know how difficult it is to do the conversion...- JspecVR4
- Thread
- Replies: 1
- Forum: Technical Discussions
Main Bearing Specs
I am currently rebuilding a 1990 JDM galant vr4 engine. Today we were installing the main bearings and realised that the bearings that we ordered from our local auto parts store is smaller than what was previously installed(rebuilt by the previous owner). Does anyone have any experience with...- JspecVR4
- Thread
- Replies: 5
- Forum: Technical Discussions
Centre Gauge Pods
I'm from Australia and I have recently acquired a jdm galant vr4. It is a 1990 and is in pretty rough condition. The centre part above the air vents where US galants would have the badge number has been ripped out and it looks ugly. I am thinking of putting dual gauge pods there at some point to...
