Thanks all. That is what I remembered, but wasn't sure if there were options.Board scores again!

Hi board,Had a 4g64 block / 4g63 head hybrid motor built a few years back. The shop is no longer in business, but I need to know which timing belt you use for this combo.Thanks in advance,

Thanks to Randy for flying out from St. Lou, Mo to pickup the car. Should be a fun drive home. 1392 is off on a new adventure...

I've updated the post with new information.

I thought the battery might be the case, I have been very busy (hence the lack of response on here) so I haven't checked the battery yet. Pending that the battery is the culprit, the price will be raised for the car running. Again, fastest way to reach me is via email.

****I have replaced the battery that was bad with a brand new one and I reset the ECU (the battery had glitched the ECU) and the car is now running again.****For sale is my 1991 Mitsubishi Galant VR-4 (#1392/2000). These cars came to the U.S. in limited production in 1991 (2000) and 1992...

Mine got crunched in a wreck. Need a replacement. If you have one you would be willing to part with, let me know.Thanks in advance, Greg

Hi all,Turbowop kindly sold me 1051's original rear bumper. Now I'll be a part of historyThanks everybody that replied.

Got smacked in the drivers rear quarter and need a new bumper skin on my '91. I'll need the side marker and support bracket on that side as well. Car is sitting at the body shop so I need these pretty quickly. Would prefer local (Seattle area) but beggers can't be choosers.Any help...

Just got done doing this. Not easy, but the solution for me was pretty easy. I used the stock location, but had to make a set of heavy washers with one side ground away ("D" shaped). Then I used my vice to squeeze the brackets as much as possible to still fit over the new bushing. Lastly, I...

Hey QuadStroke,You realize that I picked up your car in Daytona Beach, FL and drove it back (sight unseen) to Bellevue. Two and a half days including dinner with my sister in Topeka. Daytona Beach -> St. Louis -> Denver -> Bellevue. Considering it was only running on three cylinders and the...

Hi Andre!That is what I thought. I just didn't want to force fit it and be wrongWrestling with front sway bar removal this morning. Once I figure which way to twist what I'll get rolling again.Thanks for the reply and we'll be talking soon about the exhaust and motor mounts. I've...

I have the other bushings for the upper and lower control arms (and yes, one has the offset inner). This is a much bigger bushing for the rear swing arm. I was assuming that it was like the front swing arm, but can't tell how I'm suppose to install it. This is the only installation picture I...

Hi all,I joined the JSBC this weekend! No problems, just finally getting around to my Whiteline install.However, I'm feeling pretty stupid as I can't figure out where the W0624 bushing goes in the rear. The bushings don't come with any instructions and the Whiteline website doesn't...

I used a 4G64 block with 8.5:1 pistons. Mildly ported head with 264 cams. 14B and all stock fuel and air plumbing. In this configuration it makes 200 whp - 210 lb/ft. on 7.5 lbs boost (no boost reg, just hard plumbed) and runs on regular gas. No ping until you heat saturate the stupid stock...