Interested in the lower control arm set.

Looking to pick up both front and rear whiteline swaybars. Mostly interested in the rear bar for right now. Thanks!

Anyone have these parts available in good condition? I know shipping might be expensive but I'm willing to pay for rust free parts.

Looking for a good condition oem turbine housing for 16g. If you have a wastegate actuator to go with it that would be great. Thanks

Looking to pick up an FP manifold. They seemed to be everywhere a few months ago but I haven't seen one pop up in a while.

I'll take the service manuals, good sir.

Pm sent

Quoting joec: More info on cutting the hard pipe and replacing it with fuel hose: http://www.autoperformanceengineering.com/html/gvr4_3000gtnt.htmlAlso, from the above site: "If you need to use a piece of fuel hose inside your tank, be sure it is SAE J30R10 spec hose. That hose is high...

You aren't that far from me. Let me know when you're free and I'll bring my compressor up.

Quoting Terry Posten: I'll keep 134a and know that the only bomb is a possible fuel leak.Do you guys know how AC leaks were searched for back a few years ago? They use a propane tank with a flame protected tip and if the flame changed colors at the vents and around fittings/core, you had a...

I was looking into retrofitting 115 for R-134a but when looking at all the proper things that need to be done in order for the system to last it would just be cheaper to stick with R-12. Anything having to do with your A/C system isn't going to be cheap which makes doing it right the first time...

So I pulled the trans apart tonight and found the shift rail end was my problem.No real carnage to speak of, the trans is pretty damn clean.Im sure this looks pretty familiar...

Haha, carnage pics to come...

Yeah I just downloaded the service manual from lilevo and was doing some homework. I noticed I would have to punch out the end nut "detents" to get to the good stuff and remove the shift fork assembly. So I'll be getting those parts along with the new shift fork from TRE. Theres also a decent...

Ok I'll be attempting this as soon as i get the new fork and roll pin. Thanks again for the quick replys and sound advice. Maybe a how to opportunity awaits...