The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

Register Log in
  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Recent content by rgeier11

  1. Need DSM mechanic near chicagoland

    Remove the alternator and take it to autozone for testing. If you can not perform this task, post your car for sale.

  2. Hot no-start

    Do you have a way to see what the ECU sees? I agree on the coolant temp sensor would be my first test.

  3. 560 build thread

    Your manual boost controller. The other end of the boost controller should "T" into the BOV vacuum line.

  4. FS: WTT: 2004 Pontiac GTO $8500obo

    For sale is a Black 2004 Pontiac GTOAll pictures were taken 2/24/2015 and this is how the vehicle currently looks.This is an adult/original owner vehicle. This vehicle has zero mechanical problems, none. This car has an automatic transmission with the LS1 5.7L engine. The vehicle has...

  5. FS: 91 Mitsubishi 3000GT VR4 **5406** ORIGINAL MILES** Tampa FL $21,900

    Seats don't look factory. Can someone post a picture of another vr4 with that seat pattern?

  6. COP Issues

    Ditch the COP setup altogether. People have gone 9's, possibly faster on the stock coils.

  7. 30amp ignition fuse blown

    That also goes to the alternator.I bet your alternator has a bad diode or the red wire is shorting out. I ran into a similar issue and a new alternator solved it.This happened to me when I accidentally grounded out the alternator while wrenching with the battery connected.

  8. ODB Plug has no power

    You will have to back probe at the ECU to see if there is around 4.5V coming out of it.You will need to measure voltage at pin 2 of the large connector (of the three ECU connectors).See this chart clickEdit, just saw that you live in denmark. I don't have wiring diagrams for their...

  9. Bent shift rail/broken fork? Transmission Question

    How close am I to grenading if that clip is broke/loose?

  10. Bent shift rail/broken fork? Transmission Question

    When I shift into 4th gear, it shifts in too smooth. Almost as if its not even in gear. When shifting in any other gear, I can feel the bang going into each gear to let you know its in/out. Even when I shift out of 4th gear, it feels like it was never even in there.I know something is...

  11. Automatic swap into galant vr4 NEED HELP

    I'm Facebook buddies with the owner. All of the old threads kept saying foreignmuscle.com, but the site was NLA. Found him on facebook and BAM, done.

  12. Automatic swap into galant vr4 NEED HELP

    Everything you need wiring wise is here clickGo to the top where it says "Tech" and it will pop right up. Your welcome

  13. FS: 92 VR4 866/1000 not running +more $1500

    I'm interested, see private message. You can also e-mail me at [email protected] or call 847-627-0240

  14. Need Help on AC

    This is the best picture I could get.

  15. best way to remove rear ball joints?

    Add tension with a pry bar. While the tension is on, use a pickle fork/air hammer. Done.
See more
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned
Top