Hot Bits are on 570. They're perfectly fine for me, as they give the car a very stable feel. I wish I had more to compare them to, but I don't. Only issue I have with them is that they are noisy with the solid pillow ball mounts up top, but you only hear them when you're driving on crappy roads...

#4 in the diagram switches the fans to high-speed. If the controlling wire touches ground, it will activate the relay and fans(I think it's Black/Blue). Also, the fans get switched on via ground on GVR-4's, so power is always there. If you rewired new fans into the car, double check your wiring...

An EVO 3 radiator will fit, however, a bit of shimming is needed in order for it to fit snugly, as the height is a bit shorter. As Spatchana said, many don't come a bung for a fan switch. If you decide to have one added, be aware that 3/8" NPT will fit the factory sensor well enough, but the...

Which MAS is plugged in? I'd try using a stock 1g MAS, and disconnecting the GM MAF. If the car is starting and then turning off, the CAS is getting a signal to the ECU, which is what turns the fuel pump on, not the key. However, the CAS may still be installed wrong. There's a dot on one ear of...

I had a warped pressure plate that gave me a ton of trouble before I finally figured it out. It didn't feel like I was hitting something with the pedal, but the pedal never passed the "tight spot" that most pedals have before getting easier (difficult to explain). If it were me, I'd start from...

Just like the title states, looking for a white trunk lid. I don't need the wing. Located in NC. I'm only looking for one that has decent paint and no rust/dings.

I've had bad results with black.

PM'd

I'll take the 2g manifold, pending pictures. PM paypal info.

Why, so you could see them in my car? GLWS OP.

I'll take the inner fenders. Send me paypal info.

I killed 3 starters in 6 months due to a BS being out of phase. The bendix went bad in all of them, solenoid and motor still functioned as it should, but the pinion just wouldn't engage the flywheel.

I need the passenger side front lower inner fender plastic.

Quoting MuffinMan7580: The fan switch at the bottom of the radiator controls low speed (green and blue wires) and the blue and black wire at the back of the thermostat housing controls high speed.Fan switch should be green and black wires, not sure why I put blue.

The fan switch at the bottom of the radiator controls low speed (green and blue wires) and the blue and black wire at the back of the thermostat housing controls high speed.