Buyer left a deposit today. Coming back the 17th for title transfer.I'll bump this if the sale falls through.Jeremy

New Years Bump.I'm back in town where the car is stored for the week, and then again later in January.Jeremy

Yes still for sale. Unfortunately, I am travelling for work much of December. Next time I'll be around the central PA area is early January. I have a few PMs (replied to) and a few emails/calls from the CL listing, that I have been communicating with.JeremyI am also going to take some...

Thanks GST!I had the front fender liners out when I was replacing the front bumper and foglights. There were some pine needles and leaf debris in there, but I cleaned it out. I'll snag a few more photos of that area and put them on dropbox full res folder, if it isn't sold tomorrow. A local is...

Forgot to add a few details:Replaced inner and outer tie rods (front) @166K New rack boots at same time.I have a LSD rear end and axles that go with the car when sold as well. (not installed)Jeremy

Selling the Galant. It has been a fun time, but work and a move limit my interest in maintaining the relationship with this car. Lots of recent work, fine example of a mostly stock and intact VR4.Details: 1991 Galant VR4 Black Non sunroof car number 842/2000. ~170K miles (see photo for...

Thanks, it seems like this was the cause. Fluid drops at start up and then levels off. The hoses to the rear end seem to be damp, soft and leaky. Honestly the rubber lines look like they are tired and could explode at any minute.I'm going to remove the rear wheel system when I swap the rear...

So I located a 3 bolt LSD rear end. Does anyone know if the internals or function of this diff (looks like a viscous) is different or the same as the internals to 4 bolt?I know they use different axles (cups and hubs), but wondering if for a non drag race stock hp set up this will be an...

Quoting EMX5636: This is an oldie, but still holds true, aside from the tuning aspect. Skip the SAFC/piggybacks and go straight for DSMLink. You'll thank yourself now, and in the long run.clickThis has some good info as well. Again, dated, so skip the old school tuning, and spring for...

Quoting Gtpdz: The only way to trigger the light on is low on ps fluid in the reservoir, if it's not low try look into the fluid level sensor circuit.Fluid level is good, and the wires on sensor seem to test fine. The light is only on at start up for a few seconds (not every start). When...

Thanks, I'll check fluid first.Jeremy

I have 842/2000 in Nile BlackNo Sunroof Black on Black with purple tint (soon to be removed) Picked up in Atlanta, GA Kept clean and out of the salt mostly in PA currently, headed to MI soon.Jeremy

Is there a thread or VFAQ that explains what to do to increase power output on a completely factory VR4?I have searched but came up fruitless, hoping for something with the basics to check to ensure engine performance is optimized or safely increased on stock components.Jeremy

Anybody know what or why the light for 4WS would stay on after start up? It stays lit solid for 4-5 seconds with accompanying pump noise. Not on every start up, but several in recent weeks.Jeremy

I did this last weekend while changing out a heater core. Ordered parts from Mouser:Part numbers and links here:1 RoHS: Compliant1 667-ECA-1EHG101 ECA-1EHG101 100uF 25V click2 RoHS: Compliant1 667-ECA-1HHG220 ECA-1HHG220 22uF 50V click3 RoHS: Compliant1 667-ECA-1HHG470 ECA-1HHG470...