The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Recent content by CBBOOST

  1. Very clean rear seats

    I have the back and bottom seat cushions left over from my GVR4 that I’d like to sell. Both parts are in perfect shape. I will get pictures up next time I’m near the seats. Local sale would be preferable but I can ship at buyers expense. I’m in the greater Boston area
  2. New Owner of 1459/2000

    I started to feel like I was never going to use this car after building it and storing it for years. I never actually put it up for sale because I had built it for me and was so afraid of someone not understanding how special these cars are. I couldn't handle the idea that someone would buy it...
  3. Gas tank repair

    I did my tank with a combination of welding and POR15 tank sealer. I cleaned it in and out with POR Marine clean, welded what I wanted to, cleaned it again, used POR metal ready and then the tank sealer on the outside and on a few spots inside. They say to pour it in the tank and roll it around...
  4. FS: 1990 Car & Driver and Modified Mag (1051 ZOMG!)

    Thats awesome. I have the same collection!
  5. Head Identification

    I agree,1G 7-bolt head. They are pretty much the same as a 6-bolt head appearance wise with the exception of the larger exhaust manifold end studs.
  6. 5 lug swap question

    For the front you will remove the hub, pull the inner seal off, press the spindle out of the hub, remove 1 large bearing from the spindle along with the outer seal. So you need an inner and outer seal for each front wheel and one bearing for each side Koyo bearings would be the OEM replacement...
  7. WTB: Fender Liner Set

    Yea, I would do that. It will get me one step close to done. All I need otherwise is the little pieces for the rear wheels and I should have everything. I actually posted in your part out thread.If anyone has the little pieces for the rear please let me know, thanks.
  8. WTB: Rear Seat back in Great shape

    I have a perfect back seat but I'm trying to figure out what your looking for. A perfect back seat or the cheapest seat you can find in good condition??To me a hard to find perfect seat and the cheapest seat you can find are two different items.
  9. WTB: Fender Liner Set

    I'm looking for a set of fender liners including the little pieces for the rear wheels. I have the left front but if yours is better I'll take it. When my car was painted the body shop left them all in my trunk. I just went to install them only to find out that they are for a different car.
  10. FS: 960 Full partout UPDATED

    I could use a full set of fender liners if you have them.I'm not a newbie, I was a member here for 5-10 years but haven't signed in for a while so I guess my account got deleted. I actually think I worked on the car your parting out for a while! This is going back about 8-10 years.
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned
Top