The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Recent content by 4dr_vr4

  1. FREE: Free DSM transmissions for pickup in the Fredericksburg, VA area

    Enough interest already. I will update if no one takes them.
  2. FREE: Free DSM transmissions for pickup in the Fredericksburg, VA area

    Local Pickup OnlyI have the below 3 transmissions that need to be picked up. You must pick them all up, take them with you, and then go about your day. If you don't take all 3, you waive your right to take any of them. You must wear a mask when arriving and observe social distancing. This...
  3. Gas needle not reading full on full tank after replacing fuel pump.

    Thanks, will check the resistance values. I think that is all that is left. Arm sits exactly where it should.
  4. Which radiator?

    Unsure, but good find on that thread. So what is it that makes you lose A/C by using a 1g radiator? Does it have something to do with that connector on the thermostat housing for the GVR4? If so, previous owner left that harness disconnected and AC works fine.
  5. Which radiator?

    Thanks guys. You have to delete your AC to go the 1g route? Are you sure. I won't go without A/C.The Amazon radiator looks like it has the bung but I am worried about fan spacing. That radiator is also sold on ebay and not sure if they are all the same but a quick search seems to show people...
  6. Which radiator?

    It is time to replace my stocker and I'd like to replace it with an aluminum one. I have a 1g mishimoto laying around along with a 1g parts car to pull the thermo housing from.I'd also like to keep my A/C. I have read the posts here on how to make the swap. Is there another better option...
  7. Gas needle not reading full on full tank after replacing fuel pump.

    Thanks everyone. I am clocking it correctly. I just replaced the wally 190lph with a 255lph and no change unfortunately after reinstallation. I guess I'll just live with it.
  8. Gas needle not reading full on full tank after replacing fuel pump.

    The float arm isn't bent at all though.
  9. Gas needle not reading full on full tank after replacing fuel pump.

    It reads somewhere like 5/8 full on a full tank. I searched around here and noticed that I am not alone. It has been like this since I replaced the stock fuel pump with a Wally 190 about 3 years ago. I finally have a little bit more time on my hands and replaced the pump with a Wally 255 I had...
  10. Silver strip on the doors and bumpers...some questions about it.

    I plasti dipped my entire car and I am having trouble getting the sprayer to cover those silver strips from not only a coverage perspective (hard to get the plastidip in there to cover the strips) but from an adhesion perspective (plastidip not sticking very well to those strips).I guess my...
  11. Ratcheting noise coming from the rear when turning.

    Thanks man. I'll go investigate when I can find more time...always something!
  12. Ratcheting noise coming from the rear when turning.

    I am getting a bad cv joint like noise from the right rear when making right turns whether it be slow or fast. The car sat for a long time.I have a 3 bolt LSD on it at present and a 4 bolt sitting on a donor car...however I'd rather just keep the 3 bolt if possible.What might this be...
  13. FS: Clear headlight protectors for '93 headlights

    Just wanted to say that I got around to installing these. They arrived fast, were well packaged, and were nicely cut. Laid down beautifully. The seller was polite and informative every step of the way.For me it was the thought of having to replace my 93 lights that have perfect reflectors...
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned
Top