The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Shifter cable install

Eztoril

Well-known member
Joined
Aug 31, 2016
Messages
80
Location
Irvine CA
Hi everyone,

New to GVR4s here but not new to DSMs. Working on getting the galant back up and running. Installing a set of shift cables and the rubber boot is just not cooperating. Trying to get it to sit in place and its damn difficult. Anyone with any ideas to get it in place properly? I will post up pics of the car once I pull it out of the garage. I searched but couldn't find anything that would help my situation.

Thanks in advance.
 
Last edited:

Eztoril

Well-known member
Joined
Aug 31, 2016
Messages
80
Location
Irvine CA
Figured it out. One of those things I don't ever wish to replace again. Advice for anyone else doing this put some Vaseline on the rubber boot and then lots of finesse. There is no easy way to do this job unless you already have the dash removed. My interior was complete and I only removed the center console. If anyone has any questions about this let me know?

Thanks
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top