The Top Mitsubishi Galant VR-4 Resource

Join the best E39A 1991-1992 Mitsubishi Galant VR-4 community and document your GVR4 journey.

  • Software Upgraded - Reset Your Password to Login
    In order to log in after the forum software change, you need to reset your password. If you don't have access to the email address you used to register your GVR4.org account, you won't be able to reset your password. In that case, follow the instructions here to regain access to the forum.

Tubular crossmember

Imjordan

Active member
Joined
Aug 12, 2013
Messages
34
Location
Columbia, SC
Ive been looking at the bullfab crossmember for my vr4. I also keep hearing about a few others that make them but cant seem to find them. Anyone know these people?
 

Imjordan

Active member
Joined
Aug 12, 2013
Messages
34
Location
Columbia, SC
Thanks
 

BENE38A

Well-known member
Joined
Sep 2, 2013
Messages
261
Location
New Zealand
I went with one of Paul's, piece looks excellent! cant say anything about fitment yet but I haven't heard anything bad.
 

Imjordan

Active member
Joined
Aug 12, 2013
Messages
34
Location
Columbia, SC
I've been looking at 3 different ones now. Let me know how it fits
 

Olson

Well-known member
Joined
Oct 7, 2006
Messages
1,237
Location
Moreno Valley CA
those little plates that are bolted to the chassis and stock cross members. Do not run the car with out them they are there for a reason
 

BENE38A

Well-known member
Joined
Sep 2, 2013
Messages
261
Location
New Zealand
Bolted up the crossmember, sat the engine in and it fits great. I'm using avid racing 90A mounts so there wasn't alot of movement to get it all lined up but by just lifting and lowering the engine I got it all lined up without to much effort.
The roll stopper on the crossmember is a solid mount.
 

transparentdsm

Well-known member
Joined
Jul 27, 2011
Messages
3,690
Location
Cherry Hill, NJ
Quoting Olson:
those little plates that are bolted to the chassis and stock cross members. Do not run the car with out them they are there for a reason




yeah to hold the nose on the car, the stress cracks ive seen put in frames from people taking these out to do a clutch or trans and never reinstalled is scary.
 

Imjordan

Active member
Joined
Aug 12, 2013
Messages
34
Location
Columbia, SC
I ended up with one from Paul that was an older one for a 1g. but i got it for 40 bucks. it does not have the N/S bars however i wont be beating on the car until i can get one with the bars. I only bought this one because i needed to get it running. and i couldnt use the factory one.
 
Support Vendors who Support the GVR-4 Community
Boosted Fabrication ECM Tuning ExtremePSI Fuel Injector Clinic Jacks Transmissions JNZ Tuning Kiggly Racing Morrison Fabrications RixRacing RockAuto RTM Racing STM Tuned

Recent Forum Posts

Top