GalantVR4.org The Mitsubishi Galant VR-4 Forum
Galant VR-4 Forums » Galant VR-4 » Technical Discussions » Intake manifold and TB sizing
Previous thread Next thread

Intake manifold and TB sizing


tektic
Senior Member


Galant VR-4 org Post #: 1240941 posted 12/13/17 08:38 AM     Remind Me!  Send Private Message   Edit Post   
For my next project I'm going to be using a smim. I'm using it primarily because its easier to set up for Rwd. It's runners and plenum are very large compared to a stock cast unit. They are however not as smooth. This is still however a street build and I don't want something with zero power below 3k.

I have 3 different stock size throttle bodies I can use. If I use the smallest one, from my mighty max, Will it be more responsive in the lower rpm range?


Edited by tektic (12/14/17 10:38 AM)

Posts: 1396 | From: ronkonkoma, ny | Member Since: 12/19/12 | IP: (47.20.58.51) | Report this post to a Moderator


Pages: 1
Previous thread Next thread

Extra information
0 registered and 3 anonymous users are browsing this forum.

Galant VR4.org Moderator:  curtis, steve, atc250r, jcgalntvr4-244, cheekychimp, jepherz, Rausch, toybreaker, iceman69510, pot, FlyingEagle 

Print Thread

Forum Permissions
      You cannot start new topics
      You cannot reply to topics
      HTML is disabled
      UBBCode is enabled

Rating:
Thread views: 643

Rate this thread


News & Events: News | Events
Galant VR-4: Newbies | General VR4 Discussions | Technical Discussions | How To and Info Archive
Marketplace: Parts For Sale | Cars For Sale | Good Guys | Bad Guys
Community: Members' Showcase

Contact Us | Privacy statement GalantVR-4.org

Generated in 0.208 seconds in which 0.202 seconds were spent on a total of 14 queries. Turbo powered.


Hertz's Galant VR-4 Page